Posted

print

favorite this post KTM 450 SXF - VA Street Title! - $5995 (blacksburg) hide this posting unhide

123456

2011 2011 KTM 450 SXF

condition: excellent
engine displacement (CC): 450
fuel: gas
odometer: 3
paint color: white
title status: clean
transmission: manual

I have a special 2011 KTM 450 SXF for sale! This bike raced a few pro national rounds in 2011 for a shop in Texas called SMS racing. I picked it up in 2014 after it had sat since 2011. At the time I also had a 2012 450sxf and this was supposed to be my built supermoto race bike to replace that one. I did a full build on this bike and in the past few years I just haven't put many hours on it. I don't get to VIR but once a year so it sits in dirt trim. Because I haven't been riding much supermoto I went through the process to get a VA Street Title and start stock piling parts to make it street legal. It isn't there yet but it could be with a little more work.
More info about the bike and what it has.
AMA Pro Race bike with custom valved suspension(pretty stiff and im 210lbs)
VA Street Title(not south dakota or anything funny, it was done at the Christiansburg DMV)
Fully rebuilt High Compression (13:1) Motor with less than 3hrs on it. still runs on 93 octane pump gas
Motor has a brand new clutch(10mins on it), head was redone at Point View Cycle including a valve job. Point view also honed the cylinder and setup the crank end play for me but i built the motor. KTM factory rod kit and KTM rebuilt the crank. Lots of new parts including cam chain, guides, intake cam and cam gear, main bearings, seals etc.
DJH Manual cam chain tensioner
DNA black on black rims (21/19) with decent tread tires but they are old
Carb was just fully rebuilt including removing the mid body and replacing all gaskets in it and hot start valve. extended fuel screw and jet kit (It could probably use a bit more jetting work to be fully dialed in)
Twin Air fireproof filter and backfire-less filter cage (aluminum cage with no screen)
New front brake pads and freshly bled brake
Shorai light weight battery
KTM Hard Parts high flow water pump
KTM Hard parts clutch slave guard
Good chain and sprockets(renthal orange ano rear) 13/52
Frame gripper tape
Tusk aluminum gas cap
Warp 9 footpegs (or stock if you prefer)
Trail Tech 90w lighting stator and flywheel weight(have the stock 20w one as well)
New ignition coil and plug(have spare plugs as well)
KTM Stepper seat(or stock if you prefer, i have multiple bikes these fit so only one seat goes)
DDR Coolant recovery tank
Hour meter with tach
Acerbis Brush Guards
P3 Skid Plate(Plastic, i had a carbon eline on there but chipped and hung up on stuff so went to plastic)
Dr.D 3 piece exhaust with removable USFS Approved spark arrestor screen
Aftermarket shifter
New grips with KTM bar ends(easy to switch between wrap around guards for supermoto)
Custom graphics on white plastic.(can also swap out a set of orange plastics with custom graphics)

For Full asking price I will include the following.
KTM OEM Headlight , New never wired $150
UFO LED Tail light(also note the rear fender has the mounts for the OEM KTM rear light still $50
Hydro brake light switches (2) $40
Fork Seal kit $25
Fold away UFO mirror
Triangle Stand

Most of the time on the bike since being rebuilt was in supermoto form. It has done maybe 30min in the dirt total since rebuild. It does not come with supermoto parts.

I loved my 2012 450 sxf and i bought this one to build up, but i have just spent too much time recently riding my 250xc two stroke and this bike just sits. I don't need to sell it, but would love to see it actually get some use. Currently the bike starts and runs but does pop a little on decel. I am going to reseal the exhaust flange at the head as i think this is the cause and richen up the fuel screw.

So, a fully built, like new 450 motocross bike with a street title! If anyone is considering trying to do this think about the amount of time, money and effort that goes into a 4t build as well as actually getting it legally titled in VA. I spent several hundred dollars in special KTM tools alone.

Note that the pictures have the stock seat not the stepper seat i used for supermoto, and again supermoto parts not included.
  • do NOT contact me with unsolicited services or offers

post id: 6932066352

posted:

updated:

best of [?]